![]() ![]() I though it might be due to centrifugal switch mechanism and electrodes that do not well operate.I tried to check if the centrifugal switch. ![]() But I think there might be something wrong as it took too much current under no load test and the generated heat sounds weird. as it is class B motor, it can reach to 80 C. The full load current is 6.4 A based on the motor characteristics label but when I run the Motor with No load, its current reach o 7.2 A !!!!Īfter 5 to 10 min operation, the motor case get hot. it turns well and the torque sounds good. I far as i understood, the 3.1 ohm coil is the starter coil as it goes to starter capacitor. the motor runs well and no noise comes out from motor. what I find is two separated coil, one with 2.5 Ohm resistance (blue - Yellow) and second one with 3.1 ohm (Black-Red). I did a beep test to find the connections between coils and wires. I cleaned the connectors and checked them all and all sounds good. I removed all dusts and add some oils to the bearings.īearings are ok. I cleaned it up and it sounds that all components are ok. I got it from a friend that did not use it for a while. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |